Washer Won’t Drain? Repair in Hattiesburg, MS
Full tub, standing water or a drain code. Here is what to check, and when to call us.
A washer that will not drain is usually blocked or has a failed drain pump. Check the pump filter, the drain hose and the standpipe first. If those are clear, the pump is likely worn. We repair drain faults at your Hattiesburg home for a $75 service call and a written price before any work.
Why won’t my washer drain?
Four things cause almost every drain complaint. Work through them in this order.

| Cause | How to spot it | Fix |
|---|---|---|
| Clogged pump filter (front-loaders) | Water stays, humming or no pump sound | Clear the filter at the bottom front |
| Kinked or blocked drain hose | Slow drain, gurgling, water backs up | Straighten or clear the hose |
| Blocked standpipe or house drain | Water rises in the standpipe or sink | Clear the line; may need a plumber |
| Failed drain pump | Loud buzz or silence, filter and hose clear | Replace the pump |
What should I do first?
- Unplug the washer.
- Check that the drain hose is not crushed behind the machine.
- On a front-loader, put a towel and shallow pan under the small filter door at the bottom front. Open it slowly, let the water out and clear the filter. Look for coins, socks, hair clips and lint.
- Pull the drain hose out of the standpipe and make sure the pipe itself is not clogged.
- Plug in and run a drain and spin cycle.
If the water will not come out and the filter is clear, the pump is the next suspect.
How do I get water out of a washer that will not drain?
On a front-loader, the filter drain tube lets you empty the drum bit by bit into a pan. On a top-loader, use a bucket and a cup or wet-vac, and do not lift a full tub. Wear gloves, and keep the floor and electrics dry.
What does a failed drain pump sound like?
A pump that hums or buzzes but does not move water usually has a jam or a worn impeller. A pump that makes no sound at all often has an electrical fault. Grinding or rattling means something hard is stuck inside. Either way, once the filter and hose are clear, the pump is the part to replace.
Drain problems in older Hattiesburg homes
In older houses around Midtown, Oak Grove and downtown, we often find long, shallow drain runs and old galvanized standpipes. These collect lint and soap over decades, and the washer backs up even when the machine is fine. If water rises in the standpipe when the washer pumps out, the house drain needs clearing, not the washer. We will tell you which one it is.
Soft water, too much soap
Hattiesburg’s soft water needs less detergent than most labels suggest. Extra soap builds a film in the pump and hose and slows drainage. If you measure detergent and use HE soap in an HE washer, drain problems drop a lot.
What drain repair costs in Hattiesburg
The service call is $75. Clearing a blockage is usually part of the visit. A drain pump replacement typically runs about $180 to $300 with parts and labor. See the full cost breakdown. Brand codes: Samsung 5E and LG OE.
A real drain repair from our files
A Hattiesburg homeowner called us because their front-load washer stopped draining. At the end of every wash cycle, water stayed in the drum and clothes came out soaking. They had restarted the machine and tried another cycle, and were worried they would have to replace it.
Our technician went straight to the drainage system, checking the drain filter, the drain hose and the drain pump. A blockage was stopping the wastewater. We explained the problem and the fix first, then cleared the blocked components, checked the hose for other obstructions, examined the pump for damage, reassembled everything and ran a test cycle. Water drained properly, and the customer avoided an unnecessary replacement. The lesson: a washer that will not drain is often repairable.
What if the washer drains slowly instead of not at all?
Slow draining is the early warning. It usually means lint or soap is building up in the pump or hose, or the standpipe is partly blocked. Fix it now and you avoid a full tub later. Using less detergent helps more than you would think.
Brand codes that mean “cannot drain”
Samsung shows 5E, SE or nF (see Samsung washer repair). LG shows OE (see LG washer repair). Whirlpool and Maytag may show F9 E1 (see Whirlpool and Maytag repair). The error code guide lists them side by side.
Related problems and where we work
If water is on the floor, read washer leaking water. For front-loaders, see front-load repair, and for top-loaders, top-load repair. We repair drain faults in Petal, Purvis, Sumrall, Lumberton and Laurel. See all areas, the FAQ or book a visit.
What customers say
Excellent washing machine repair service
“My washing machine suddenly stopped working in the middle of a laundry cycle, and I had no idea what was wrong with it. I contacted their team, and they were very helpful from the beginning. The technician arrived on time, carefully inspected the machine, explained the issue, and fixed it without any unnecessary delays. The washer is working perfectly again. I’m really happy with the service and would definitely recommend them to anyone needing washing machine repairs.”
Washer won’t drain questions, answered
Why is my washer full of water and not draining?
The usual causes are a clogged pump filter, a blocked drain hose or standpipe and a failed drain pump. Unplug the washer and check them in that order.
Can a clogged drain hose stop a washer draining?
Yes. A kinked, crushed or clogged hose is a common cause. Pull the machine out a little, check the hose and clear or straighten it.
How do I unclog a washing machine drain pump?
On a front-loader, open the filter door at the bottom front, drain the water into a pan and clear out debris. On other models, the pump is behind a panel and may need a technician.
Is the washer or my house drain the problem?
If water rises in the standpipe or backs up into a sink or tub when the washer pumps out, the house drain is blocked. If the pump is silent or the filter is full, the washer is the problem.
How much does it cost to replace a washer drain pump?
The service call is $75, and a drain pump replacement typically runs about $180 to $300 with parts and labor. You get a written price first.
Can I run the washer if it won’t drain?
No. Standing water can overflow, damage the floor and strain the motor. Unplug it and bail the water out before you call.
Tub full of water? We’ll get it draining.
Call (601) 419-6599 for a written price before any work starts. 2624 Lincoln Rd, Hattiesburg, MS 39402. Monday to Saturday, 8 a.m. to 6 p.m. Request service for washer not draining Hattiesburg today.