Washing Machine Repair Cost in Hattiesburg, MS
Real price ranges for common washer repairs in Hattiesburg, and how to decide between fixing and replacing.
Washing machine repair in Hattiesburg usually costs $150 to $300 for common jobs such as a drain pump, door lock or inlet valve, plus our $75 service call. Bearings and control boards run $250 to $500. You get a written price before any work starts.
How much does washer repair cost in Hattiesburg?
Prices below are typical ranges with parts and labor. Your exact price depends on the brand, model and the part. You always get it in writing before we start.
| Repair | Typical range |
|---|---|
| Service call and diagnosis | $75 |
| Lid switch or door lock | $150 to $250 |
| Drain pump | $180 to $300 |
| Inlet valve | $150 to $300 |
| Drive belt | $125 to $225 |
| Door boot seal | $150 to $250 |
| Hose repair or replacement | $120 to $200 |
| Suspension rods or shocks | $175 to $300 |
| Motor coupling or clutch | $175 to $325 |
| Bearings or control board | $250 to $500 |
What affects the price?
- Brand and model: some parts cost more, especially on newer smart washers.
- Part availability: common parts are on our truck, and rare parts may need ordering.
- How much work is involved: bearings and tub seals take much longer than a pump.
- Location: most Pine Belt addresses use the same $75 service call. Call about farther areas such as Laurel.
Is it worth repairing a washer or should I replace it?
A simple rule: if the repair costs more than about half the price of a comparable new washer, or the machine is more than about 10 years old and needs a major part, replacing usually makes sense. If it is under eight years old and needs a pump, lock, boot, belt or valve, repair almost always wins.
Quick guide
- Under 8 years old and a small repair: fix it.
- 8 to 12 years old and a mid-priced repair: weigh it up with us.
- Over 12 years old and bearings or a control board: usually replace.
We will tell you honestly, even if that means no repair.
Is the service call credited toward the repair?
Call us and ask. Policies on service calls vary, and we explain ours when you book so there are no surprises.
How to avoid paying for repairs you don’t need
- Check the basics first: taps open, hose clear, filter clean, load balanced.
- Have the model number ready when you call.
- Ask for a written price before approving work.
- Do routine care: monthly clean cycle, measured detergent and an open door between loads.
Local note: repairs on rentals
If you rent near USM or manage a rental, we can send the written estimate to the owner or property manager for approval before work starts.
Three real repairs and what they involved
Prices make more sense with real jobs behind them. These are three recent Hattiesburg calls from our files. We have left out the prices because every washer and part is different, but the work shows what you are paying for.
1. A front-loader that would not drain
The drum was full of water after every cycle. We checked the filter, hose and pump, found a blockage and cleared it, then tested a full cycle. The customer avoided buying a new washer. See washer won’t drain for the usual causes.
2. A top-loader banging and walking at spin speed
We checked leveling and suspension, found faulty suspension components, replaced them and tested a spin cycle. The noise and vibration dropped. See top-load repair.
3. A front-loader that would not start
A faulty door-lock assembly stopped the cycle starting. We replaced the lock, checked the connections and ran a full wash. See front-load repair.
How to read a repair estimate
A good estimate separates three things: the diagnosis (our $75 service call), the part and the labor. Ask what the part is, whether it is new, and what the warranty covers. Ours is 30 days on the work we do. If a quote is only one lump sum with no part named, ask for more detail before you agree.
Questions to ask any washer repair company
- What is the service call, and is the repair price given in writing first?
- Do you diagnose at my home, or take the washer away?
- What warranty comes with the repair?
- Will you tell me if it is not worth fixing?
Our answers are on the repair FAQ and the about page.
Price by problem
The most common calls are drain faults, leaks and spin problems on top-loaders. Brand-specific notes are on Samsung, LG and Whirlpool and Maytag pages, and codes are decoded in the error code guide.
Where the $75 service call applies
The same call applies in Hattiesburg, Petal, Purvis, Sumrall and Lumberton. For Laurel and farther towns, call first. See all areas we serve or contact us.
What customers say about pricing
Honest pricing and professional work
“I’ve had some disappointing experiences with repair services in the past, so I was a little hesitant to call someone new. However, these technicians made the entire process easy. They explained what was wrong with my washing machine, discussed the repair cost before starting the work, and completed the job professionally. I appreciated their honesty and attention to detail. It’s great to find a repair company that values its customers.”
Washer repair cost questions, answered
How much does washing machine repair cost in Hattiesburg?
The service call is $75. Common repairs such as a drain pump, door lock or inlet valve run about $150 to $300 with parts and labor. Bearings and control boards cost more.
How much does a drain pump replacement cost?
Typically about $180 to $300 with parts and labor. You get a written price before any work starts.
At what price should I replace instead of repair?
If the repair is more than about half the price of a similar new washer, replacement often makes sense. Age matters too.
Do you charge for estimates?
Our $75 service call covers the visit and diagnosis. You get a written price for the repair before any work.
Do you offer a warranty on repairs?
Yes. We back repairs with a 30-day warranty on the work we do.
Can I get a price over the phone?
We can give a rough range if you tell us the brand, model and symptoms. The exact price needs a diagnosis, because similar symptoms can have different causes.
Want an exact price? Call and describe the problem.
Call (601) 419-6599 for a written price before any work starts. 2624 Lincoln Rd, Hattiesburg, MS 39402. Monday to Saturday, 8 a.m. to 6 p.m. Request service for washer repair cost Hattiesburg today.