How to Clean a Washer Drain Pump Filter
Most front-load washers hide a small filter behind a panel at the bottom. Cleaning it fixes many drain problems.
Most front-load washers have a drain pump filter behind a small panel at the bottom front. To clean it, unplug the washer, put a towel and shallow pan down, slowly unscrew the filter, clear coins, lint and debris, rinse it, screw it back in firmly and close the panel. Do this every few months.
Where is the pump filter?
Look for a small door or panel at the bottom front corner of a front-loader. Behind it is a round filter cap, often with a small drain tube. Top-loaders usually do not have a user-serviceable filter.
How do I clean it?
- Unplug the washer.
- Lay a towel and a flat pan under the panel. Water will come out.
- Open the panel. If there is a drain tube, pull it out and let the water drain into the pan.
- Slowly turn the filter counterclockwise and pull it out.
- Clear coins, lint, hair and debris. Rinse the filter and look into the opening.
- Screw the filter back in firmly, close the panel and run a short drain cycle to check for leaks.
How often should I do it?
Every three to four months for most households, and more often with pets, kids’ clothes or lots of towels.
What the drain pump filter does
The filter is a small trap that sits in front of the drain pump and catches coins, hair ties, buttons, lint and other things that could jam the pump. Most front-load washers have an easily reached filter at the bottom front, behind a small door. Many top-load washers do not have an owner-serviceable one, although some have a lint filter inside the tub.
Before you start
- Unplug the washer.
- Put a shallow baking pan and a stack of towels on the floor. Expect a cupful to a few cupfuls of water, and sometimes more if the washer did not drain.
- Check your manual for the exact location and any model notes.
Step by step
- Open the access panel at the bottom front of the washer. Many panels pop off with a coin or a fingernail.
- Look for a small drain hose clipped near the filter. If there is one, pull it out, lower it into the pan and open the cap to drain the water slowly.
- Turn the round filter counterclockwise, slowly, with the pan underneath, and let remaining water run out.
- Pull the filter out and remove everything that has collected: coins, lint, hair and debris.
- Rinse the filter and look into the opening for anything stuck near the pump impeller.
- Screw the filter back in until it is firmly seated and the panel is closed.
What you might find
| Finding | What it means |
|---|---|
| Coins, buttons, hair ties | The usual cause of a clogged drain |
| Thick lint and slime | Too much detergent or no regular cleaning |
| Sock or cloth fragments | Small items passed through the drum; check pockets and use mesh bags |
| Broken plastic pieces | The pump or drum may be damaged; call us |
How often
Every three to six months for most households, more often if you wash pet bedding, work clothes or lots of small items. Cleaning it also prevents the musty smell that comes from stale water. If the washer still will not drain after you clean the filter, see washer won’t drain.
Common mistakes
- Forgetting a pan, which leads to a flooded floor when the filter comes out.
- Cross-threading the filter when putting it back; it should turn smoothly, so back it out and start again if it does not.
- Skipping the drain hose and opening the filter at full speed, which sends the water out in a rush.
- Forgetting to put the access panel back, which can leave an opening that leaks.
How long it takes
Allow about fifteen to twenty minutes, mostly for draining and drying. After you finish, run a short rinse cycle and check around the filter for drips.
What if it still will not drain?
If the filter is clean and the washer still holds water, the hose or pump may be the cause. See washer won’t drain. For a real example, our drain repair on the front-load page shows what we check.
How to clean a washer pump filter questions, answered
Where is the filter on my washer?
Behind a small panel at the bottom front of most front-loaders.
Is it safe to open the filter?
Yes, if the washer is unplugged and you have a towel and pan ready. Water will come out.
Why is there so much water when I open it?
The filter holds whatever is left in the drum and hose. Drain it slowly.
What if I find a coin or a sock?
Remove it, rinse the filter and test with a drain cycle.
What if it still won’t drain?
The hose or pump may be at fault. Call us for a repair.
Still not draining? We’ll fix it.
Call (601) 419-6599 for a written price before any work starts. 2624 Lincoln Rd, Hattiesburg, MS 39402. Monday to Saturday, 8 a.m. to 6 p.m. Request service for clean washer pump filter today.